Descriptions & Pricing

Please Contact Us For Pricing... Thank You!!

Roadbed Description

4 1/2" wide 3/4" thick, roadbed surface 3 3/4" wide for G and Standard scale 3 1/2" wide 3/4" thick, roadbed surface 2 3/4" wide for O27 and O scale made of unfinished oak veneered furniture plywood with beveled side edges that are not veneered. A 1/2" wide by 3/8" deep wiring trough runs the top center-line of all roadbed sections. (All roadbed sections connect together with 2 - 3/8" dowels.)

• Components available to fit LGB G gage & R1 curves ( 60cm - 23 5/8" radius )
• Straight roadbed in lengths up to 7 feet ( Max. length for U.P.S. shipment 6 foot )
• Single curve sections
• 90 degree curve sections
• Right hand switch with 300mm straight and 90 degree right curve on exits
• Left hand switch with 300mm straight and 90 degree left curve on exits
• Right hand switch with 300mm straight and 30 degree left curve on exits
• Left hand switch with 300mm straight and 30 degree right curve on exits
• ( 300 mm = approx. 1 ft. )

Components available Standard, O27 and O gage

• Straight roadbed in lengths up to 7 feet ( Max. length for U.P.S. shipment 6 foot )
• Single curve sections
• 90 degree curve sections
• Switch sections made to order
• Supports (All supports are made of solid oak)
• Single roadbed wall support per drilled for roadbed screw (for use under straight sections)
• Single roadbed ceiling support (for use under straight and curved sections)
• Long wall support (for use under two track straight aways and switches)
• Corner wall support (for use under curves)

O & G tunnel sleeves (to finish wall opening from one room to another)

• Through truss bridges made to your specified length from Cedar
• Elevated roadbed supports These are for creating an elevated section on an existing layout.

HIGH-ISLES ^tm Are mounting bases for scenery, display of collectables and use under switch machines. Made of the same material as HIGH-RAILS® roadbed They have a back edge designed to fit the roadbed and a free-form outer edge beveled the same as the roadbed. Custom sizes are available.

Unfinished wooden components only. Track & mounting hardware should be obtained locally.