Descriptions & Pricing

Roadbed Description

4 1/2" wide 3/4" thick, roadbed surface 3 3/4" wide for G and Standard scale 3 1/2" wide 3/4" thick, roadbed surface 2 3/4" wide for O27 and O scale made of unfinished oak veneered furniture plywood with beveled side edges that are not veneered. A 1/2" wide by 3/8" deep wiring trough runs the top center-line of all roadbed sections. (All roadbed sections connect together with 2 - 3/8" dowels.)

Components available to fit LGB G gage & R1 curves ( 60cm - 23 5/8" radius )
Straight roadbed in lengths up to 7 feet ( Max. length for U.P.S. shipment 6 foot )
Single curve sections
90 degree curve sections
Right hand switch with 300mm straight and 90 degree right curve on exits
Left hand switch with 300mm straight and 90 degree left curve on exits
Right hand switch with 300mm straight and 30 degree left curve on exits
Left hand switch with 300mm straight and 30 degree right curve on exits
( 300 mm = approx. 1 ft. )

Components available Standard, O27 and O gage

Straight roadbed in lengths up to 7 feet ( Max. length for U.P.S. shipment 6 foot )
Single curve sections
90 degree curve sections
Switch sections made to order
Supports (All supports are made of solid oak)
Single roadbed wall support per drilled for roadbed screw (for use under straight sections)
Single roadbed ceiling support (for use under straight and curved sections)
Long wall support (for use under two track straight aways and switches)
Corner wall support (for use under curves)

O & G tunnel sleeves (to finish wall opening from one room to another)

Through truss bridges made to your specified length from Cedar
Elevated roadbed supports These are for creating an elevated section on an existing layout.

HIGH-ISLES ^tm Are mounting bases for scenery, display of collectables and use under switch machines. Made of the same material as HIGH-RAILS® roadbed They have a back edge designed to fit the roadbed and a free-form outer edge beveled the same as the roadbed. Custom sizes are available.

Unfinished wooden components only. Track & mounting hardware should be obtained locally.

Click Here For Pricing